manual Clip-ons

Clip-ons

  • Firstly put togehter clamp, riser and tube and set the whole left or right (just one) clipon to the desired position on the bike. Tighten the bolts slightly
  • Then check the markings on the assembled side and prepare the second riser with clamp to the exactly same position like on the other side (not on the bike). Tighten the bolts in clip-on slightly.
  • Assemble the second tube at the same position like on the other side and tighten the bolts in the riser.
  • Assemble prepared second side on the bike a turn by whole clip-on until it is in the same position like on the other side.
  • When the setting is according to your preferences, tighten all "A" and "B" bolts two times. Recommended tightening torque is 9Nm

manual clipon_01

  • Notice: Threads of the bolts are lubricated by grease because of better friction features in the thread connection. Be carefull during the manipulation. Keep the bolts lubricated and don´t degrease them by cleaner.

 

Clipony

  • Nejdříve sestavte objímku se stojnou a tyčí dohromady na jedné straně, nastavte na motocyklu do požadované polohy a dotáhněte šrouby lehce.
  • Potom zkontrolujte značky na namontované straně a připravte si druhou objímku a stojnu ve stejné poloze (mimo motocykl) Dotáhněte lehce šrouby objímky.
  • Namontujte druhou tyč do připravené objímky se stojnou a dotáhněte lehce šrouby stojny.
  • Tuto druhou stranu namontujte na motocykl a otáčejte celým cliponem dokud nebude ve stejné poloze jako na druhé straně.
  • Jakmile je vše nastavené podle Vašich představ, dotáhněte šrouby "A" a "B" dvakrát. Doporučený utahovací moment je 9Nm.

manual clipon_01

Poznámka: Závity šroubů jsou namazané mazivem kvůli optimalizaci tření v závitovém spoji. Buďte opatrní při manipulaci. Udržujte šrouby namazané a neodmašťujte závity čističem.